Tool length adjustment from the lateral side is possible
Simple length adjustment _ all you have to is to turn 　the guide ring

Internal coolant feeding is possible.
Maximum coolant pressure: 　
Tool shank diameter 19mm and below:7MPa
20mm and above:5MPa(coolant collet is optional)
(NOTE)In the case of UTS, two types are available - high pressure and low pressure.

Tight and secure tap drive.
Tap driver is incorporated to securely hold the 　square part of a tap. (Preset driver is optional.)

１. Tap projection length can be adjusted easily by turning the guide ring.
２. Center-through coolant feeding is possible (Max. ５-７MPa). 　Except for UTS.
３. Slippage of tap can be prevented by preset driver.
４. Tap size can be changed by replacing preset drivers and collets.